
Central Control Module 7896 2-5
Revision F2005-2 F-Type
S, .H\SDG
The numeric keys [0] to [9] and the decimal point [.] are used to select a particular
cue or memory number in conjunction with one of the function keys listed below.
Key Meaning Function
[Sys] SYSTEM Calls up the SYSTEM SETUP menu.
[Mem] MEMORY Selects one of the non-volatile internal memories.
[Clr] CLEAR Clears a selected memory (i.e. sets everything to
OFF)
[Err] ERROR Writes error message or information to alphanumeric
display.
[Esc]
ESCAPE Moves backwards through a menu, or aborts an
operation, can be thought of as a “cancel” button.
[Bsp] BACKSPACE Deletes the last number entered.
[Rcl] RECALL Recall a cue or memory.
[Sve] SAVE Store a cue or memory.
[
↵
] ENTER Selects a menu item, starts or acknowledges
operations.
The arrow keys, [
←
], [
→
], [
↑
] and [
↓
] are used to help navigate in the various menus.
The buttons are back-lit by LEDs, and will illuminate or flash to indicate that they will
perform a useful function if pressed at that time, or that their function has been
selected.
Unlabelled buttons are reserved for use in future software updates.
T, 35(9#DQG#1( ;7#EXWWRQV
Use the previous or next button to recall snapshots from the automation cue list to
the console.
51414 6DIH25HDG\2:ULWH
The following instructions refer to the group of switches on the CCM labelled
“MOTOR FADERS”. See also 3.1.25 Ready and 2.1 m) Motor Faders.
To put all motor faders in SAFE mode: Press “ALL SAFE” switch.
To put all motor faders in READY mode: Press “ALL READY” switch.
To put a small number of motor faders in READY mode:
a) Press the “SET READY” switch.
b) Touch each fader knob that is to be recorded and make fader movement required.
c) Press the “SET READY” switch (to cancel the function).
Kommentare zu diesen Handbüchern