Cadac LIVE1 Bedienungsanleitung PDF herunterladen (Seite 17)

Revision L1.1 2011-12Live1

14. Headphone output – this is a single ¼” (6.35 mm) 3-pole (TRS) jack

socket carrying the same signal as at [13] above, but in unbalanced form

and at a level suitable for driving headphones of 16 impedance, or higher.

This connector should be wired as follows:

Pin Connection

Tip Left monitor output

Ring Right monitor output

Sleeve Screen (common)

15. Talkback mic – a 3-pin female XLR for connection of a talkback

microphone. Sensitivity and input impedance are the same as those for

the mic channels. Note that phantom power is permanently active at this

connector. The connector should be wired as per the table at [1] above.

16. Line in – this is an unbalanced stereo line input to the Master L/R mix.

The L and R buses are fed equally. Nominal input level is 0 dBu, input

impedance 10 k

. The connector is a 3-pole ¼” (6.35 mm) jack socket, and

should be wired as per the table at [4] above.

17. Littlites – 3-pin male XLR connector(s), providing 12 Vdc at for the

connection of Littlite

lamps. The current capability of each connector is

1 A. The DC supply has an internally resettable fuse. The Live1 Model

1642 is ﬁ tted with one Littlite connector, while Models 2442 and 3242 each

have two. Littlites are directly compatible; if using other types of lights, the

connectors should be wired as follows:

PIN Use

1 n/c

2 +12 V

3 0 V

18. Mains input – see “Powering the Live1” on page 11

It is always good operating practice to turn a mixer on BEFORE turning on

the ampliﬁ ers, etc., to which its outputs are connected. Similarly, always

turn the ampliﬁ ers off BEFORE turning the mixer OFF.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Keine Kommentare

Cadac LIVE1 Bedienungsanleitung Seite 17