Cadac R-Type Bedienungsanleitung PDF herunterladen (Seite 130)

GLOSSARY-XII

R-Type Revision R2005-2

Send Bus A set of wires accessible to all sends.

SET button SET buttons are found on the FCM and the

channel faders and are used for DC Master and

Mute Group assignments.

SLEEVE The part of a 0.25” TRS jack connector which is

connected to the cable screen to provide earth

connection.

snapshot A snapshot is defined as a single memory loca-

tion within the CCM, which takes an instantane-

ous snapshot of the current console setting, i.e.

stores and can recall the following information:

Snapshot name

Currently selected DC master membership

Current DC master name if DC master are

labelled

Currently selected Mute Group membership and

Mute group status

Currently selected soft key mute and bypass

status

Current “snap-to” fader position (when motor

faders are implemented, which will be an option.

A snapshot has no dynamic contents.

SOLO See

solo-in-place

below.

solo-in-place Pressing the CHECK function on the

Osc&Comms module allows an operator to use

input channel MUTE buttons as a ‘solo-in-place’

for trouble-shooting.

spur A console PSU-system in a

redundant config-

uration

should be connected to the same phase

and circuit

(spur)

stereo group Group module configured for stereo operation.

stereo master bus Dedicated stereo mix bus.

STEREO MUTE Function on the Listen & Stereo module that

mutes the stereo output.

stereo pair Sends 1 -8 can be set to be stereo pairs; e.g.

sends 1A and 1B reproduces L & R instead of a

mono signal that is identical for A and B.

string Combination of characters constituting the

name of a memory location.

sub-group Normally receives a signal via an on/off switch

only, with no independent level control.

sub-output Level controlled output of the resulting mixed

signals of the sub-group.

summed signal One or more signals that are electronically

added together.

switch-mode power supply A power supply whose operation is based on

high-frequency switching and may or may not

include an input transformer stage. The switch-

mode power supply output voltage variations

are filtered out by an LC filter.

test signal A signal that has a known voltage or power

level.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 138 139

Kommentare zu diesen Handbüchern

Keine Kommentare

Cadac R-Type Bedienungsanleitung Seite 130

Kommentare zu diesen Handbüchern