Cadac R-Type Bedienungsanleitung PDF herunterladen (Seite 69)

Stereo Input Channel 8231 8-3

Revision R2005-2 R-Type

;1416 3KDVH#UHYHUVH#

These buttons enable you to reverse the phase of the incoming signals of the left and

right MIC amps independently or together.

;1417 3)/#0#/#DQG#5

Pressing this button enables you to monitor the left and right MIC amps via the PFL

system. Pressing L or R will send a mono signal to the left and right busses of the

Listen module. Pressing both buttons together will send a true stereo image to the

L & R of the PFL-bus.

;1418 /LQH0XS#WRQH

Press this button to apply a Line-up tone to the input. The frequency and level of the

line up tone applied is controlled from the OSC/Comms module 8271, see 11.1 Osc

& Communications 8271 - front panel. Pressing this button will also disable the 48v

phantom power if selected, see 7.1.6.

;1419 7;9#SKDQWRP#SRZHU

Press this button to switch on the 48V Phantom power to any connected microphone.

Notice that the 48 v phantom power is disabled on this channel if the line-up tone is

selected (see 7.1.5).

;141: 053G%#3DG

Press this button to apply -20dB attenuation to the input signal to the L & R micro-

phone amplifiers. If the gain potentiometer (see 8.1.1 Input Gain LEFT/RIGHT) is set

for 20dB and the pad applied, this allows for the use of line level (0dB nominal)

devices instead of having a separate line input.

;141; /()7#.#5, *+7

Press this button to sum the LEFT and RIGHT MIC amp signals to MONO.

;141< 2XWSXW#WR#0DWUL[

These buttons are used to select direct routing to matrix busses 13 to 16 from POST

fader, with or without stereo panning. See 8.1.33 Matrix 13 - 16 and 8.1.28 PAN Con-

trol.

;14143 6HQGV#<$2%#0#49$2%

Sends 9A/B - 16A/B are dedicated mono sends, each with its own level control. Each

pair has its own PRE/POST FADER and ON/OFF switch.

Sends 9A/B - 12A/B and 13A/B - 16A/B can be selected to follow the STEREO PAN-

NING by using the buttons in the panning section at the bottom of this module. See

8.1.28 PAN Control, 8.1.30 Stereo PAN to groups 9 - 12 and 8.1.33 Matrix 13 - 16.

;14144 6HQGV#4$2%#0#;$2%

Sends 1A/B - 8A/B can be switched between stereo and dual mono. In stereo, adjust

the level with the upper control and panning with the lower one. In dual mono, adjust

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 138 139

Keine Kommentare

Cadac R-Type Bedienungsanleitung Seite 69